Holtey Classic Hand Planes
Where precision toolmaking becomes art
|No.982 Side view
||No.982 Lever cap detail
Having made traditional infill planes for over 20 years and been aware of their shortcomings, it was inevitable that I would take a long and serious
look at planes in general. I have taken the infill plane to a higher standard of precision and detail and you would be hard pressed to find its peer.
The problem with infilling is that the plane becomes vulnerable to the dimensional instability of wood. Even though I have remained fairly loyal to the Norris
patterns and made many improvements to them, there is still this piece of wood that is shrinking and expanding with environmental changes. It is either
pressing on the sides or contracting away from the sides.
In order to maintain the standards and precision that I have always wanted to achieve I have had to take the wooden stuffing away, but still retain
the wooden handles. The changes have been incorporated into my No 98 series. By using a fabricated design I have gained some advantages:
- A better choice of materials
- Easier access
- Improved accuracy all round
- Unrivalled uniformity
- Excellent finishing texture on the internal faces
The material being used in the No 982 is hot rolled black steel which has no stresses. Unlike the No 98, the No 982 uses a combination of screwing
and taper pins, this is extremely strong and adds no stress, compared to peining. I will discuss the importance of stresses in my blog.
All of my wood work is Danish oiled and waxed for the final finish. French polish or lacquer are very poor alternatives and are prone to scratching,
cracking, blooming and is difficult to maintain. The benefits of oiling are easier maintenance and, in this application, has the right finish i.e.
no clogging or veiling of the wood and it allows you to see the true beauty. I have heard it implied that oiling is the easy option, but this couldn’t
be more wrong. Some of the more experienced members of our craft will assure you that the work and standard for the preparation for oiling is considerably
higher because the oiling will show up the slightest blemish.
The lever cap has been painstakingly machined from a solid bar of naval brass (CZ112) and incorporates a Norris style square thread 7/16 x 14 tpi.
The thumb screw uses the same knurl as the adjuster knob. You will notice the lever cap has my initials KH in art deco style which will be used on
all my new planes.
98 Series development
You might have noticed that the bottoms and sides are much heavier sections than the No 98, (at least 40% extra weight) the extra weight is desirable.
This gives the plane greater accuracy and better stability, less flex in use. Most people would be very surprised if they knew how much these tools
can flex in use.
All the surfaces inside and outside are precision surface ground and hand polished where appropriate. Some people may think this is over the top but
once they have used the plane it might change their outlook. I also think I have managed to retain the classical features of this kind of tool rather
than be too contemporary.
The distinctive angled front bun is for ergonomic reasons. It feels a lot more comfortable to use.
The 982 is a not a successor to the No 98 and there will be other planes in the series based around the No 98, e.g. the next one I make will be numbered
No 983. The '2' does not mean mark 2.
There have never been any hand planes as well made and to such high standards in the history of plane making. I am hoping that the exploded drawing will indeed
convince people as to the design considerations, skill and effort that has gone into the 982’s development, as a well known tool manufacturer said I tend to hide
all my work.
|No.982 Surface grinding - a time consuming but necessary part of my process
||No.982 Fitting the adjuster knob